Board logo

標題: [others] ready fighter mb47 一問 [打印本頁]

作者: sunytwtp    時間: 28-3-2020 02:37     標題: ready fighter mb47 一問

這把real steel的身是4140鋼,
而ready fighter使用6061鋁,
由於ak bolt不像ar那樣實質接觸面積小,
因此我很擔憂會不會很容易磨損或是強度不如預期?

已經收藏的玩家可否分享一下心得,感謝!

這把資訊少,幾乎找不到人討論,好可惜
作者: uarsostupid    時間: 30-3-2020 04:26

Ching, i have a fully custom build Ready Fighter SLR GHK AK GBBR. I dont understand what u mean "實質接觸面積小". u are talking about the bolt or the receiver? The RF body is aluminum and i am using the GHK original bolt carrier(galvanized steel?) with Hephaestus Full Steel piston guide rod to increase the bolt weight. i put a lot of lubricated oil on both bolt and body for run in. I even installed W&S rapid fire kit. and it is running as smooth as butter oil. but i didnt fired it much, less than 1000 rounds, i just hang it on the wall most of time. and Bunny workshop did a great job on my AK installation. if u want to assemble a RF AK, u can seek for their advice. just for your reference.
作者: uarsostupid    時間: 30-3-2020 04:33

https://www.facebook.com/BunnyWo ... ?type=3&theater

This one is mine. For your reference.
作者: TheOrigina1    時間: 30-3-2020 04:52

引用:
原帖由 uarsostupid 於 30-3-2020 04:33 發表
https://www.facebook.com/BunnyWo ... ?type=3&theater

This one is mine. For your reference.
Is it still readily available?
I can't find it. Or do you have to commission it through bunny to get one?
作者: jn_jona    時間: 30-3-2020 09:34

其實玩具槍鋼料唔係想像中咁硬
好多時都係mild steel咁上下既野

只要冇乜起角位刮到 有定期落油都已經好ok
作者: uarsostupid    時間: 30-3-2020 14:46     標題: 回覆 4# 的帖子

no la, I source all parts myself.
作者: TheOrigina1    時間: 30-3-2020 21:31

引用:
原帖由 uarsostupid 於 30-3-2020 14:46 發表
no la, I source all parts myself.
Mind if you share where can i still get it? thanks a lot




歡迎光臨 CGF (http://wargamehk.com/cgf/) Powered by Discuz! 6.0.0