I bought a Guarder 150% spring yesterday...
but when i install, the slide can't move back.......
when i pull the slide back, normally it should slide back automatcially...
but not after installed the 150% spring...
is like just stuck...
Help me plz.... 作者: Zap 時間: 22-7-2009 12:24
I had similar problem before and resolved by using a large amount of grease and repeat sliding it manually until the ride became smooth…… 作者: pkcurtis 時間: 22-7-2009 12:32
ok.... thank you for you help.... 作者: pkcurtis 時間: 22-7-2009 14:04
Will i got any problems after i add the hammer spring?
