CGF - Powered by Discuz! Board

標題: aps2 problem 2 [打印本頁]

作者: kamikaze1988 時間: 19-4-2010 22:51 標題: aps2 problem 2

之前支APS2有底邊力但係宜家冇應該係邊度出左問題?
THX REGARDS

作者: teru 時間: 19-4-2010 23:46

what spring u use ?use #3000,#4000,#5000 is beter than PDI ,CA, GD

作者: kamikaze1988 時間: 20-4-2010 01:05

i think not the problem of spring ...

作者: teru 時間: 20-4-2010 22:52

sometime when u use new spring it can make good power,
after 1week the pwoer will deduct 10-20%,(lenght also deduct1-2CM ) i buy all type spring in maket, and test all type B4

作者: kamikaze1988 時間: 20-4-2010 22:59

oh....that why because i think my gun leak air ar...
i use laylax spring now

作者: teru 時間: 21-4-2010 00:00

if use spring up tp 210% u need to use lay lax red piston rubber.

作者: kamikaze1988 時間: 21-4-2010 23:41

yeah i am using laylax piston rubber
如果我拆過出黎裝返上去有D鬆有冇問題?

作者: kamikaze1988 時間: 21-4-2010 23:44

引用:

原帖由 teru 於 20-4-2010 22:52 發表
sometime when u use new spring it can make good power,
after 1week the pwoer will deduct 10-20%,(lenght also deduct1-2CM ) i buy all type spring in maket, and test all type B4

真的嗎?

作者: teru 時間: 23-4-2010 11:17

using laylax piston rubber;有D鬆冇問題,

作者: kamikaze1988 時間: 27-4-2010 01:25

引用:

原帖由 teru 於 20-4-2010 22:52 發表
sometime when u use new spring it can make good power,
after 1week the pwoer will deduct 10-20%,(lenght also deduct1-2CM ) i buy all type spring in maket, and test all type B4

真的?

作者: teru 時間: 28-4-2010 00:50

yes u can check it

作者: carltam 時間: 5-5-2010 19:54

想問下呢把槍既內槍管同電槍管有咩分別？

歡迎光臨 CGF (http://wargamehk.com/cgf/)