標題: PTW Motor Locking PIN [打印本頁]

---

作者: shaun.w903    時間: 10-4-2011 20:29     標題: PTW Motor Locking PIN

I have just bought a 09 Max Kit. When I install the motor, I found that the two motor locking PINs is so hard to put it in, so I ended up not intall them. The motor is still working fine without it. Any Ching know will it be problem in the future?

---

作者: Elf    時間: 10-4-2011 21:09

structurally not a problem, since the head of motor is perpendicularly locked with the lower body, and as long as your hand grip is installed, there is no room for it to rotate at all

---

作者: shaun.w903    時間: 10-4-2011 21:15

Thank you elf Ching.

---

作者: fwkwong    時間: 10-4-2011 22:58

引用:

原帖由 shaun.w903 於 10-4-2011 20:29 發表
I have just bought a 09 Max Kit. When I install the motor, I found that the two motor locking PINs is so hard to put it in, so I ended up not intall them. The motor is still working fine without it. A ...

危險啲喎.用個尖鋤執一下摩打兩個孔,又執執槍身那邊,整大小小,條PIN就可以過了,花小小工夫係險啲.

---

作者: mcderekli    時間: 11-4-2011 16:03

u can just install one motor pin ka

---

作者: hkkiller7    時間: 11-4-2011 22:06

我都2條裝曬，但要往鎚出“擊”

---

作者: ayaka    時間: 11-4-2011 22:28

我會執幼少少兩條PIN

---

作者: Elf    時間: 11-4-2011 23:55

我2粒pin人手摩左5個鐘都未入到, 算鬼數唔裝

---

作者: fwkwong    時間: 12-4-2011 00:42

引用:

原帖由 Elf 於 11-4-2011 23:55 發表
我2粒pin人手摩左5個鐘都未入到, 算鬼數唔裝

唔好磨粒pin,用鋤整大摩打個孔一啲,它的孔喺造細咗d,未執個孔絛pin跟本放唔入,度吓就知,摩打個孔好執d

---

作者: ayaka    時間: 12-4-2011 00:43

引用:

原帖由 Elf 於 11-4-2011 23:55 發表
我2粒pin人手摩左5個鐘都未入到, 算鬼數唔裝

我夾條PIN係個電鑽到, 當車床咁磨

---

作者: Elf    時間: 12-4-2011 01:02

引用:

原帖由 ayaka 於 12-4-2011 00:43 發表

我夾條PIN係個電鑽到, 當車床咁磨

掂喎

---

歡迎光臨 CGF (http://wargamehk.com/cgf/)

Powered by Discuz! 6.0.0