CGF - Powered by Discuz! Board

標題: Lion + nicd/mh [打印本頁]

作者: 生豪 時間: 17-7-2007 00:02 標題: Lion + nicd/mh

因為7.X V就太細 but 11.1就太高
can i 係7.X 鋰電+2粒nicd???而令佢有9.X v
or係11.1到+電阻
will it works???
thank you

作者: tam_sir 時間: 17-7-2007 01:32

7.X 鋰電+2粒nicd???.....可能爆炸
11.1到+電阻 .....電阻會發滾,電阻承受之電流也會很大,功率也要很大,可能會大過舊Lion電

作者: LifeAfterDeath 時間: 17-7-2007 09:58

what do u want anyway?

using Lion because want fast ROF and compact size... and remember Lion only give you 11.1V no matter the battery is full or not

using Ni-Mh because is safely reason(well I don't use Lion myself) and I use 10.8V for my C8... and remember when you fully charge your Ni-Mh battery the output in the beginning is more then 13V (if you do have a charger with display it will say your battery is 13.XV) but when your battery half full... it will give you less then 10.8V and so on...

so as I said is really up to you...

作者: maurice 時間: 17-7-2007 10:56

你想打咩力和幾快？
我用 7.4V 15C 推 M120 + 剛杯士 + 原裝扭力齒，ROF =18

作者: 生豪 時間: 17-7-2007 16:57

引用:

原帖由 maurice 於 17-7-2007 10:56 發表
你想打咩力和幾快？
我用 7.4V 15C 推 M120 + 剛杯士 + 原裝扭力齒，ROF =18

我打rof30
用first怏齒 eg1000 6mm雙油坑杯士.x4粒 6mm啤令2粒 m100 363mm管

作者: maurice 時間: 17-7-2007 17:32

你個 setting 用 7.4V 15C + Turbo motor 應該接近。

作者: ricky12hk 時間: 19-7-2007 00:08

師兄~借少少位搭一搭單問少少野~~thx a lot~

如果我用o既只係7.4v、10c~咁用快麼夠唔夠一下推行佢~?~
因為已前試過用普通8.4推快麼~但有兩段聲...佢要入左2波先開始黎料...

同埋...如果我1j弓~用11.1v 鋰電~~要點cut齒~?~兩格夠嘛~?~

麻煩晒!!

歡迎光臨 CGF (http://wargamehk.com/cgf/)