發新話題
打印

[Marui] Marui hi capa 5.1 無法擊發

Marui hi capa 5.1 無法擊發

屋企搵到支好舊既Marui hi capa 5.1
諗住唔好浪費就買左套gunsmith bors 既costa kit放落去
裝完之後插左2隻匣試,2隻匣都係打極都無反應,個feel好似無插匣就咁啪

因為身邊無另一支hi cap,
試過上身放落1911到打係work

下身亦換左硬hammer spring,
唔裝上身,淨插匣亦可以打晒D氣出黎

一旦將上下身合體就打唔到
請問係邊個位出左事?

PS. gunsmith bros 套kit入邊D sear都裝晒

[ 本帖最後由 1012 於 30-4-2020 04:02 編輯 ]

TOP

更新: 發覺飛機未入晒個HOP UP座就可以打到一次, 入晒就打唔到

TOP

If the upper set can fire in 1911, it is likely the upper set is ok.  Have you tried to install the 1911 upper set to you Hicap lower frame and test fire (you may need to remove the small sub-rail in the slide first)?

Have you replace the hand grip?  If yes, try to replace it with the original grip.  This is the first thing I would do.  If it still doesn't fire, replace with each original component one by one and test again.

You will need patience to do this kind of investigation and debug.  Good luck!

TOP

你check下係唔係個飛機同埋個disconnector同埋個firing pin磨合唔到。入夾打既時候係可以hammer down 定係就咁落半槌?你再check下飛機係唔係可以順暢移動,可以試下換個stiff少少既hammer spring
4MJ Ltd.

TOP

引用:
原帖由 matthewtse830 於 8-5-2020 14:06 發表
你check下係唔係個飛機同埋個disconnector同埋個firing pin磨合唔到。入夾打既時候係可以hammer down 定係就咁落半槌?你再check下飛機係唔係可以順暢移動,可以試下換個stiff少少既hammer spring
岩岩check左係gunsmith bro送果條fire pin lock 既彈弓仔太硬, slide唔夠力將佢壓到底, 換返原裝就打到了

TOP

發新話題