大家點睇!
(Copied from HULDRAARMS.com) 因為玩得太多軍版樣既M4! 想玩支
Custom SS Barrel! 又行
"PISTON 款" 長槍, 佢個餐單好清楚.
Specs:
Caliber: 5.56x45
Chamber: 5.56 NATO
Barrel Length: 16"
Barrel Twist: 1:8 Right Hand
Barrel Profile: MED Contour Fluted
Barrel Material: 416 SS
Barrel Coating: SS RAW
Barrel Lining: SS
Gas System: Mid Length
Upper Receiver: Dry Film Lubed
Trigger: 4.5lb JP Single Stage
Stock: Vltor IMod Mil-Spec
Grip: Ergo Ambi
Fore Arm: Monolithic Fluted
Rail Length: 18.5" Overall
Rail Width: 1.63"
Rail Height: 2.45"
Flash Hider: Adams Arms Compensator
Overall Length Retracted: 32-7/8"
Overall Length Extended: 36-1/8"
Overall Weight: 7.217 lbs.
100 Meter Accuracy: SUB MOA WITH MATCH AMMO
Magazine and Soft Sided Tactical Case Included
--------------------------------------------------------------------------------
The X-PRE is the Huldra flagship rifle. Combining the patented piston technology with a solid monolithic billet upper receiver and forearm, a 416 stainless steel fluted barrel, and the Adams Arm compensator, giving you the fastest, most stable and accurate rifle in your arsenal. This upper was designed with the precision and 3-gun shooter in mind. The mid-length gas system gives you a longer sight radius between the rear and front sight for quicker sight acquisition and a more ergonomic feel. The monolithic upper was designed specifically for this rifle. The monolithic tube is fluted to dissipate heat quicker than any other receiver and is extended around the gas block for a smoother look and better balance. It is extremely accurate, has virtually no muzzle rise, and is quick and balanced for anyone in the competition arena.
The 4.5 pound JP Trigger (a $259.95 value) gives you a perfectly crisp, precise break and extremely short reset. The complete absence of take-up and over-travel provides the best combination of speed and precision on the market. The ambidextrous safety allows you to flip off the safety on either side of the weapon. The rugged Mil-Spec Vltor IMod Stock has an extremely comfortable Superior cheek weld with a non-slip removable butt pad. Each side compartment of the Vltor IMod can hold two AA or three lithium CR123 3-volt batteries and accepts a push-button, quick detachable sling swivel. The Ergo Grip is solid and comfortable. Its superior texture reduces slippage, even while wearing gloves and is virtually impervious to oils and solvents. The upper and lower receivers are machined from high quality mil-spec 7075-T6 aluminum forgings, with critical tooling dimensions held within ±.001” and Type III Hardcoat finished. The mil-spec buffer tube is precision machined from 7075-T6 aluminum as well. The magwell front features recessed chevrons for improved control.
[
本帖最後由 rho837 於 17-8-2011 13:27 編輯 ]
