20 12
發新話題
打印

木托的滋味〈二〉Mauser K98K

引用:
原帖由 Andy 於 9-7-2011 23:56 發表

改左做1
D圖未問過物主同意轉帖與否的
偷圖
公公槍?

TOP

引用:
原帖由 Andy 於 10-7-2011 00:03 發表

唔知了
我上網睇,馬交有種牌係咩有收藏價值定唔知乜鬼
好似比香港果個唔反對你擁有的公公槍牌方便

http://www.fsm.gov.mo/psp/cht/psp_top5_di_8_1.html

香港想買公公槍又要點做呢?

TOP

引用:
原帖由 MANKF 於 10-7-2011 01:23 發表
Natrium C-Hing,公公槍個牌唔難攞,但聽啲資深C-Hing講,尼查你啲公公槍就煩啲!因為如果你有啲〝反動〞parts!佢哋可唔可以當睇唔到呢
死火好似睇唔明咩叫〝反動〞...
如果合法既公公槍+公公牌,唔會有反動part掛?
引用:
原帖由 MANKF 於 10-7-2011 01:34 發表
Oh!  Natrium,  Your Tanaka is very nice! How much it cost?
玩呢D玩具槍,我認為價錢大家都應該估到大約係幾多,只計個托應該同你差唔多
反而係放左幾多時間心機,做左幾耐研究同對reference,自我滿足一下

btw上次你講既長度問題,
我發現WaA 623托係比tanaka短少少的

[ 本帖最後由 Natrium 於 10-7-2011 14:22 編輯 ]

TOP

引用:
原帖由 MANKF 於 16-7-2011 23:35 發表
今日番埋個mount同支鏡 可以開工啦 但我發現個白痴問題
個前mount點套落支鏡度 同點樣固定支鏡唔會氹氹轉
請各C-Hing提点指教!非常感謝
You will have to take justment tower off, which means disassembly to mount the front turret.
You will have to silver solder the scope on the rings.
Some suggest arcaglass for re-act only.
For me, I am thinking about drill tapping the bottom of turret rings and use a small jimi screw to hold.

[ 本帖最後由 Natrium 於 18-7-2011 20:59 編輯 ]

TOP

引用:
原帖由 MANKF 於 18-7-2011 23:22 發表
Thanks Natrium C-Hing for all suggestions.  Due to my scope's front justment tower is very tight!  I need my friend's machine help to turn it out.  For fixing the scope firmly on the mount, what C-Hin ...
you'll have to remove bluing of position that soldered, apply thin layer of solder on the rings and the scope tube, then heat them.
REMEMBER you must remove all optical elements when you apply solder as heat may crack them.

TOP

 20 12
發新話題