阿堅

引用:

原帖由 rYaN 於 8-7-2009 17:43 發表

噤抵?平時見人放成皮野wor

唔係有國產CNC咩,好似6XXX,有鋼(8620)同鋁(7075)....
鋼重WA原裝個條100g左右...
不過6XXX唔記得係鋼定鋁....

阿堅

引用:

原帖由 ＡＬ 於 8-7-2009 19:48 發表

???
唔明..

但如果拎萬八銀去@gm
真係有d...

萬八我玩真野算....
一支真AR先七千唔洗.....

阿堅

引用:

原帖由 rYaN 於 8-7-2009 22:23 發表

自己磨走哂d補強位...

引用:

原帖由 retroblackrifle.com發表

All types or models should have the following modifications made:
1. Re-profile the rear of the receiver around the buffer tube/extension area.
This is basically a process of grinding off the reinforcement material that was added to strengthen the buffer
tube/extension area, and reprofiling the area to make it resemble the original A1 area. Use the pictures below
as an example:




2. Re-profile the front of the receiver below the front takedown pin.
This is also basically a process of grinding off the reinforcement material that was added to strengthen the
takedown pin area, and reprofiling the area to make it resemble the original A1 area. See the picture below for
an example:

3. Remove the "Safe" and "Fire" markings from the left side of the receiver.
This is a process of filling in the markings with either a putty/filler, or by welding a "bead" over them. Then the
area is ground/sanded smooth. See the picture below for an example:

慢慢整....

[ 本帖最後由 阿堅 於 9-7-2009 00:10 編輯 ]

阿堅

引用:

原帖由 Louis@銃之達人 於 9-7-2009 17:10 發表
我諗住打到支AGM打柴就del咗佢

你不如比我啦...

阿堅

引用:

原帖由 Louis@銃之達人 於 9-7-2009 17:59 發表

俾你做咩

還掂都打左柴,不如比我....
唔洗送去垃圾堆田區,環保呀

阿堅

引用:

原帖由 Louis@銃之達人 於 9-7-2009 22:21 發表

好...其實我諗諗下都想俾人，唔好哂咗啲野

咁唸咪啱
就比我啦