daiski

Hi brothers, need you advice on this.  I got this casv and when I want to install the bottom part of the handguard, it won't go in because the the part I'm pointing out is 1mm too wide.  Should I use a file to file it down?  But I'll kill the paint job if I do.  What other method do you recommend?  Any brother has this problem with CASV?
Thanks

daiski

I give up.  I realize filing down won't help because the it's at least 2mm out of place.  I try to remove part 1 to see if the casv will budge.  However it's so tough to remove the front sight.

daiski

no la it's copy

daiski

that's what I'm trying to remove. but the front sight won't come out. do i need sight removal tool to remove a gp front sight?? :x :x

daiski

引用:

原帖由 Pan 於 22-6-2007 12:04 發表

鎚仔打一枝幼既螺絲批

I've already removed the 2 pins, but the sight is so tight.

daiski

引用:

原帖由 Pan 於 22-6-2007 12:18 發表

仲有粒機米呢
係個底度

oops...how do you take that out????

daiski

never mind. i'll use an allan wrench hehe

daiski

hey Pan, thanks for your help.  finally got it done

daiski

引用:

原帖由 whisky 於 22-6-2007 12:37 發表
三角星底部，有個細細個既咚，開支電筒照入去，你會發覺裡面有粒六角形既野，個粒野就係叫機米，用六角匙樓粒機米出泥

haha, it was so small i didn't know it was a 六角.  I took it out with an allen key lu

daiski

引用:

原帖由 Pan 於 22-6-2007 13:06 發表

合得埋就得了
舉手之勞姐

對你把槍有少少提意~~~~
如果用 casv 既~~~就試下用 ARMS 既 #40 or GG&G 隻 BUIS 呢~~
同埋個 wilcox aimpointy mount 唔似太襯 CASV

i'm very poor ga. i need to buy accessory bit by bit.  i got the wilcox mount originally to go with the  mk18 look.