LifeAfterDeath

引用:

原帖由 14692 於 6/22/07 01:04 發表
cost effectiveness<----你明架?

I know... but I don't mind to do that... I want to get the best for my C8... maybe in the future when I get more M4... I may do as what you do now... but for now... this one is for myself and for my CADPAT... I willing to spend alot more in this baby...

LifeAfterDeath

after more then 9 hrs of work... I finally work it out the basic of the C8...


but isn't over yet... still lots of stuffs need to work on...

LifeAfterDeath

引用:

原帖由 14692 於 6/22/07 09:12 發表
好大條gap喎

is still W.I.P. no where close to finish...

LifeAfterDeath

引用:

原帖由 14692 於 6/22/07 09:57 發表
會唔會裝既步驟有問題?

I don't think so... I guess is the wire screwed up... cux I go from the front... not from the end...

LifeAfterDeath

引用:

原帖由 14692 於 6/22/07 23:22 發表
會唔會套模已經開始走位

I better hope not...

LifeAfterDeath

but I check the other side it doesn't have any GAP... so I think I could fix it somehow...

LifeAfterDeath

引用:

原帖由 steveyue 於 6/24/07 01:50 發表

咁都要對位呀!!
Pin 位正確, 但一邊有Gap, 一邊冇, 唔係睇唔出呀!

that was the thing that I didn't check... I am new to airsoft... and also new to M4/M16 series... so I didn't check it when I first bought it...

LifeAfterDeath

引用:

原帖由 14692 於 6/24/07 05:09 發表
睇嚟你要執執D前後pin位

I guess so...

LifeAfterDeath

引用:

原帖由 14692 於 6/25/07 05:03 發表
係大執
咁大條gap你都入到pin, 相信D位都勁錯吓.....

really... will see this weekend... I will get my dayoff on this weekend so I will try to fix it...