gino

引用:

原帖由 優之涼粉 於 15-9-2008 12:23 PM 發表
想請教各位師兄，小弟支馬記glock 17隻匣明明仲有好多彈，但打左幾發之後個滑架好似用晒彈咁卡左去後面

我換左PGC金屬滑架︴吉打150% recoil spring + hammer spring

其實關唔關隻匣的溫度事的???

I use the same parts as you did (plus some more than you don't). when i testing the slide on the gun before i shoot. i find out the slide get stuck at the end cant go back to the front. then i use the tools to fix the area get stuck between the slide and the gun (only fix on slide rail only)after that when i shoot no problem at all. try to check the slide disapart from inside. let see any part is broken. this is my story i hope can help you out!

gino

引用:

原帖由 優之涼粉 於 16-9-2008 09:00 PM 發表
d parts無爛到

remove all the part from the slide, then just put the slide on it to check the fitting, lets see it go smooth or not