rho837

Did anyone put PDI PTW barrel into the stock systema PTW M4 (Not the Chellenge Kit)!

Mine stock M4 barrel is too narrow and hardly fit the PDI into it? Any advice. Thx.

sailun412

引用:

原帖由 rho837 於 26-1-2010 18:48 發表
Did anyone put PDI PTW barrel into the stock systema PTW M4 (Not the Chellenge Kit)!

Mine stock M4 barrel is too narrow and hardly fit the PDI into it? Any advice. Thx.

they supposed to be the same inner diameter....i haven't try Pdi but my "stock" & kit are 100% the same!!

jpg

PDI should have the same outer diameter, but they are also claiming that systema outer barrel maybe have a little different on the inner batch by batch, so if your PDI doesn't work, too bad.

rho837

Machining works are no problem to me! Well I got a custom barrel that can smooth tight fit the PDI already, however, did anyone have this problem before. Regarding the existing stock barrel it looks ugly, therefore, I have AFM the inner bore which is smooth and just fit the PDI also sand blast the outer with characters etching and save it for spare barrel.

[ 本帖最後由 rho837 於 27-1-2010 11:51 編輯 ]