undefined

我最近買左枝舊式Kokusai M10左輪
而佢唔係用彈殼差氣o既,係晌槍柄到入氣o既
但返到黎唔係好識點入BB彈落d彈殼到
有無人可以好心教下我




唔fit位的

sunny

Very nice!  Is it full metal?

14692

二手? 咪就係彈殼入彈囉...

undefined

引用:

原帖由 sunny 於 14-2-2007 02:25 發表
Very nice!  Is it full metal?

no
most of the parts are plastic

undefined

引用:

原帖由 14692 於 14-2-2007 05:07 發表
二手? 咪就係彈殼入彈囉...

係
馬sir,係點入彈ga?
個彈殼都夾唔住粒彈
點先得

khwong67

In the original box, there should have a green stick that can push the bb to stuck at the bottom of the shell.

bayonet_lover

hi,

i can see that the BBs has been placed inside the bullets & it's ready to shoot now!
did you try to shoot? if it can't shoot, i think there is a gas leakage inside the gas system inside the hand grip...
some of our KOKUSAI revolvers has this problem...

this M10 4"inch barrel is NICE! (old version)
for gas version KOKUSAI M10, i just missed this one, so i bought a cap version instead.

thanks

undefined

引用:

原帖由 bayonet_lover 於 14-2-2007 10:45 發表
hi,

i can see that the BBs has been placed inside the bullets & it's ready to shoot now!
did you try to shoot? if it can't shoot, i think there is a gas leakage inside the gas system insi ...

黑色果d?
果d唔係BB彈黎ga wo~
我都試過敲出d黑色珠珠
但係個洞都塞唔入6mm BB彈

bayonet_lover

hi,

but that area is for the BBs ga wor!
that hole can't hold the BB too tight (it needs to be hold quite loose), otherwise the gas form the back can't push the BB out to the barrel.

14692

引用:

原帖由 bayonet_lover 於 14-2-2007 14:55 發表
hi,

but that area is for the BBs ga wor!
that hole can't hold the BB too tight (it needs to be hold quite loose), otherwise the gas form the back can't push the BB out to the barrel.

佢果把可能少咗樣野...呱