發新話題
打印

幾個問題..麻煩師兄入尼答一答^^

幾個問題..麻煩師兄入尼答一答^^

7.4V鋰電有無一隻係火孤11.1v三片式果隻大小?
我要放src hk416


我知打鋰電係咪要cut灰士?
點解要cut同埋唔cut會點?


cut左灰士打鋰電仲可唔可以打反模型電?


原廠野用11.1v12鋰電快頻要改咩?


咩叫攝齒??


換強化天梯邊隻好?幾錢?


電池盒大約幾錢個?

麻煩曬師兄^^

[ 本帖最後由 andy53120569 於 23-3-2008 22:21 編輯 ]

TOP

回覆 #1 andy53120569 的帖子

1. not sure
2. not related, but it's the best to do so. a FUSE is used to break the electric circuit when the current is too high to prevent overheat or damages to any parts of the system. if the fuse is absent but a large current is running through the circuit, it usually brings with the overheat of motor when concerned with an AEG.
3. if what you mean by 模型電 is the same of mine, then it's ok.
4. I don't quite understand your question, sorry.
5. i believe what you mean by that is the insertion of thin rings to the gear shaft. this is to fill up the spaces between the gears and the gearbox innerface. if you;ve got yourself a bad gearbox with bad gears without the correct settings of the rings, the gears would normally break down when used for a while.
6. not sure
7. get outside and take a look lol

TOP

回覆 #2 cccarlos 的帖子

英文...不過我大約都明既..
唔該曬師兄^^

TOP

stock src 416 run 11.1V 15C three thin stick Li-Po inside hand guard no problem so far! Only it shoots too fast
Happy Shooting

TOP

引用:
原帖由 andy53120569 於 23-3-2008 20:31 發表
7.4V鋰電有無一隻係火孤11.1v三片式果隻大小?
我要放src hk416


我知打鋰電係咪要cut灰士?
點解要cut同埋唔cut會點?


cut左灰士打鋰電仲可唔可以打反模型電?


原廠野用11.1v12鋰電快頻要改咩?

...
1.有,蛇三見過,唔記得12定16c,不過未用過唔知夠唔夠c數
2.唔一定,睇你鍾意(燒左咪cut左佢囉 )
3.打鋰電同模型電完全冇關係,cut唔cut都用到
4.http://www.civiliangunner.com/cgf/viewthread.php?tid=14913&extra=page%3D3
   應該幫到你
5.唔明...
6.army code , deep fire ...etc
7.幾十至幾百都見過,有連laser有唔連laser,睇你的須要....

[ 本帖最後由 101653 於 25-3-2008 00:48 編輯 ]

TOP

發新話題