daiski

Hi brothers, need you advice on this.  I got this casv and when I want to install the bottom part of the handguard, it won't go in because the the part I'm pointing out is 1mm too wide.  Should I use a file to file it down?  But I'll kill the paint job if I do.  What other method do you recommend?  Any brother has this problem with CASV?
Thanks

Pan

咩牌架???

devil-sniper

引用:

原帖由 Pan 於 2007-6-22 11:49 發表
咩牌架???

Vltor.....................?

daiski

I give up.  I realize filing down won't help because the it's at least 2mm out of place.  I try to remove part 1 to see if the casv will budge.  However it's so tough to remove the front sight.

Pan

引用:

原帖由 devil-sniper 於 22-6-2007 11:51 發表


Vltor.....................?

但係無奶油 vltor 都會咁 bo

Pan

引用:

原帖由 daiski 於 22-6-2007 12:00 發表
I give up.  I realize filing down won't help because the it's at least 2mm out of place.  I try to remove part 1 to see if the casv will budge.  However it's so tough to remove the front sight.

會唔會真係頂住左呢??
因為我裝果時無裝到果 part1 的~

daiski

no la it's copy

daiski

that's what I'm trying to remove. but the front sight won't come out. do i need sight removal tool to remove a gp front sight?? :x :x

Pan

引用:

原帖由 daiski 於 22-6-2007 12:02 發表
that's what I'm trying to remove. but the front sight won't come out. do i need sight removal tool to remove a gp front sight?? :x :x

鎚仔打一枝幼既螺絲批

daiski

引用:

原帖由 Pan 於 22-6-2007 12:04 發表

鎚仔打一枝幼既螺絲批

I've already removed the 2 pins, but the sight is so tight.

Pan

引用:

原帖由 daiski 於 22-6-2007 12:18 發表


I've already removed the 2 pins, but the sight is so tight.

仲有粒機米呢
係個底度

daiski

引用:

原帖由 Pan 於 22-6-2007 12:18 發表

仲有粒機米呢
係個底度

oops...how do you take that out????

daiski

never mind. i'll use an allan wrench hehe

devil-sniper

引用:

原帖由 Pan 於 2007-6-22 12:00 發表

但係無奶油 vltor 都會咁 bo

o甘無o野o拉.............

whisky

三角星底部，有個細細個既咚，開支電筒照入去，你會發覺裡面有粒六角形既野，個粒野就係叫機米，用六角匙樓粒機米出泥